Need metal roof installation in Geneva? We come look first, tell you plainly what it needs, and put the price in writing before anything starts.
A metal roof is what Roofing Brothers is known for, and it has been since 2002. On a Geneva home that means standing seam or exposed fastener panels set over sound decking and real underlayment, with the ridge, valley and eave trim cut and fit on site rather than forced out of a box.
Not every Geneva roof needs the biggest job on the sheet. When we quote metal roof installation we tell you honestly whether a repair will hold, whether doing one section will do, or whether you are genuinely past that — and we would rather do the smaller job well.
Metal is our specialty, so if metal roof installation on your Geneva home opens the door to standing seam or a panel roof, we will price that right alongside the shingle option and let you compare the real numbers side by side.
Four steps and no surprises. This is how we have done it since 2002.
Nothing gets ordered until you have a written price in hand and have settled on the color you actually want.
Where the decking is sound and there is only one layer, we can often go over the top on purlins. We tell you which one your house calls for.
Synthetic underlayment over the whole roof, ice and water shield in the valleys and at the eaves, then panels set square on the correct fastener spacing.
Then the yard gets picked up, the scrap gets hauled off, and a magnet goes over the drive before we pull out.
The things people want to know before they tell us to go ahead.
Much less than people expect. Over solid decking with underlayment, a Geneva metal roof sounds about like a shingle roof from inside. The loud tin roof people remember was screwed to open purlins on a barn.
Around twenty standard colors. Green, burgundy, bronze, black, gray, tan and barn red are the ones most Geneva homeowners land on. We bring the chart with the estimate so you can hold it against your siding.
Installed properly over sound decking, a metal roof should give a Geneva home 40 to 60 years. Standing seam often goes longer because there are no exposed fasteners to work loose or leak.
A straightforward Geneva house is usually three to five days. A cut up roof with dormers, valleys and multiple pitches takes longer, because every panel and trim piece gets measured and fit on site.
Real feedback from homeowners we have worked for.
"Metal roof on the barn and one on the shed while they were already out here. Good work on both and the price was fair for that much steel."
"Thank you so much to the entire crew at Roofing Brothers for our amazing new tin roof! You were amazing to work with and I couldn't recommend you to others enough! Great communication, pricing, color options, efficiency, and HONESTY! If anyone needs a new roof, I highly recommend this crew! Phenomenal job."
"They reroofed the porch and matched it to the house so well you cannot tell where the old work stops and the new starts."